Be Cool Travel Carrier + Manual Del Usuario página 15

EN
it gently. When you hear a "click", and the red and
green indicator sticker on the base is showing in
green, the installation is complete.
Note: When finished installation, the infant carrier will not
be shaked around.
2: How to disassemble:
Push the basket release button with one hand, and
gently lift the handle of the basket with the other
hand to remove it.
4.1_ USE THE ISOFIX+SUPPORT LEG TO
INSTALL THE INFANT CARRIER
Note: When the child is over 60cm, the headrest and slee-
ping pad should be removed.green indicator sticker
on the base is showing in green, the installation is
complete.
1: First release the support leg of the base (see 3.9);
then release the ISOFIX attachment (see 3.8); place
the base on the vehicle seat;
The backrest of the base should against the car seat.
2: Put the child in the infant carrier and lock the
28
buckle;
After the base is fixed, place the infant carrier with
the child on the base (see 3.10), the red and green
indicator sticker on the base is showing green and
then check the seat is locked;
Push the handle of the infant carrier to gear 3 (see
3.5), as shown in the picture.
4.2_USE THE ADULT THREE-POINT SEAT
BELT TO INSTALL THE INFANT CARRIER
Note: When the child is over 60cm, the headrest and
sleeping pad should be removed.
1: As shown in the picture, place the baby into the
infant carrier, lock the buckle, tighten the Y-shaped
strap (see 3.4), and then put the infant carrier in
reverse on the vehicle seat. Ensure the infant carrier
to be in close contact with the vehicle seat backrest
(please refer to the precautions before installation
for details).
Precautions before installation
Note: The bottom plane B of the infant carrier should be in
close contact with the vehicle seat cushion to ensure
that the plane A and the plane C are in balance; the
D point should be in close contact with the vehicle
backrest.
2: as shown in the picture, pull out the adult three-
point belts, and insert the adult three-point belts into
the infant carrier belt ( 2 ) guide on the same side.
3: As shown in the picture, first, insert the car seat
belt into the car seat belt slot and hear a "click"
sound, check whether it is locked. Then encircle the
shoulder belt and pass through the belt guide
hook ( 3 ) on the back of the infant carrier. lap straps
After the seat belt is fixed, the seat belt slot and the
seat belt guide cannot be in this relative position. If in
doubt, please consult the product manufacturer!
4: As shown in the picture, keep the infant carrier in a
stable position, press the handle adjustment buttons
on both sides of the basket with both hands, and
turn it clockwise to gear 3 (see 3.5 ), and the handle
is just against the seat.
Note: Ensure that the seat belt is not twisted, under the
premise of not causing discomfort to the child, the
seat belt should be tightened as much as possible.
5_ THE MAIN TECHNICAL PARAMETERS
• Distance from front to back of the seat:733mm
• Distance form left to right of the seat:440mm
• Height of the seat:496mm
• Weight of the seat:9.4 ±0.5kg
EN
29