SOLAC ET8924 Instrucciones De Uso página 12

ET8924.book Page 12 Friday, June 22, 2007 11:18 AM
Wall mounting
1 Place the wall support on the floor in the position shown in the figure
(fig. 1) and mark the top screw holes on either side of the support on the
wall (fig. 1).
2 Drill the marked holes and insert the plug (fig. 2).
3 Install the support, aligning the bottom screw holes with the matching
screws, and tighten the screws (fig. 3).
4 Holding the support from below, repeat the process in step 2 (fig. 3).
5 Lastly, tighten the screws to securely attach the support (fig. 4).
6 Check that the support is anchored in such a way that it can withstand
twice the weight of the appliance.

If the support is damaged, do not reuse it.

For installation on a plastered brick wall, use the following: 4.2 x 25 DIN
7981 screws and 6 76 NY wall plugs. For other surfaces, consult the
expert salesperson.
Safety distances
• The radiator must be installed at 150 mm from any obstacles, walls, etc.
• The distance from the appliance to the floor should be 220 mm. It may
be less in certain cases, but never less than 150 mm.
Installing the feet (not included accessory)
• Insert the edges of the bottom of the radiator into the feet as shown in
figure 5. You will hear a click to indicate that the installation was a
success.
3 Operating mode (models: ET8924, ET8926, ET8928,
ET8930, ET8932. Digital thermostat)
Components
1 Keypad
1.1 Reduce selection key
1.2 Increase selection key
1.3 Mode/OK key
1.4 ON/OFF/PROG switch key
A Humidifier
1 Once the appliance is installed and correctly connected, press the ON/
OFF/PROG key to switch on the heat emitter.
12 Operating mode (models: ET8924, ET8926, ET8928, ET8930,