Publicidad
Idiomas disponibles
Idiomas disponibles
ET8924.book Page 14 Friday, June 22, 2007 11:18 AM
Possible errors of the thermostat
• If the probe is at less than -15ºC, the screen will display the message
OC.
• If the probe is at more than 50ºC, the screen will display the message
SC.
4 Programming
1 Make sure that the thermostat is in the OFF position or press the ON/
OFF/PROG button to go to the off position.
2 Press the ON/OFF/PROG button for at least 5 seconds to go to Manual
Programming.
3 Select the hour-by-hour operating mode by pressing the "+" button and
then "Mode/OK".
• Top segment: Comfort
• Low segment: Save
• Nothing: Anti-frost.
4 Repeat the operation for each hour of each day of the week.
• When you finish programming day No. 7 on the thermostat, the
parameters are saved automatically and the program changes to the
hour adjustment mode in order to ensure that the time is correct. Modify
the time if necessary or validate to return to the OFF position.
5 Use the "-" button to move through the program schedule. This button
moves through the time zones without modifying the program. Press
continuously to accelerate the process.
5 Setting the clock time
1 Make sure that the thermostat is in the OFF position or press the ON/
OFF/PROG button to go to the OFF position.
2 Press the ON/OFF/PROG button for at least 5 seconds to go to Manual
Programming.
3 Press the ON/OFF/PROG button once.
4 Select the day by pressing the "+" and "-" buttons and then the "Mode/
OK" button to validate.
5 Select the time by pressing the "+" and "-" buttons and then the "Mode/
OK" button to validate.
14
Programming
Publicidad
