Publicidad
Idiomas disponibles
Idiomas disponibles
• The filter should be cleaned or replaced periodically to prevent
insufficient air flow caused by a buildup of dust particles. Poor air
flow will cause overheating, reduce the performance of the unit
and add more risk.
• This appliance is designed for INDOOR DOMESTIC USE ONLY.
• The appliance shall not be installed in a laundry room.
• Please note that below notice for A018I-09C, A018I-09CH,
A018I-12C and A018I-12CH: due to the power input of this
product on start up, voltage drops may occur and this can
influence other equipment (e.g. dimming lights). Therefore we
advise you to make sure that your product is only connected
to a supply with a maximum permissible system impedance
Zmax= 0.367 Ohm. If you require further clarification, you may
contact your local power supply authority.
IMPORTANT! THE UNIT IS DESIGNED TO
OPERATE BETWEEN 18ºC AND 35ºC. THE UNIT'S
PERFORMANCE MAY BE GREATLY REDUCED IF
ROOM TEMPERATURES EXCEED THIS
TEMPERATURE RANGE.
• Before using the unit, place the
unit UPRIGHT for at least 1 hour
before use to allow the refrigerant
to stabilize. If the unit was tilted
on its side or upsidedown during
transportation, set the unit upright
for 4 hours before use.
• For optimal efficiency, the unit must
be operated in an enclosed area.
Keep all doors, windows and other
outside entrances to the room
closed.
• Place the unit at least 31 cm away
from other objects (e.g. curtains or
furniture) that may restrict airflow
front or through the air vents of
the unit.
• The unit must be positioned on a level floor.
5063022060242_MNL_IN_V04.indd 9
5063022060242_MNL_IN_V04.indd 9
9
12-12-2022 16:08:05
12-12-2022 16:08:05
Publicidad
