Publicidad
English
35940 WJ
(Continued on the next page.)
P. 10
STEP 3:
Attach the Goal End Boards (#6) to the Top Slat Boards (#5)
using two Brackets (#63) and four Screws (#57) per Bracket.
See Fig. 3A.
Insert the two Scorers (#39) into the Scorer Support (#8) and
attach the Scorer Support aseembly to the Slat Top Board (#5)
using two Screws
(#60) per Scorer Support assembly.NOTE:
Make sure the Scorers (#39) are facing down when assembly.
See Fig. 3B.
Attach the Goal End Board Assembly (#5 and #6) to the Side
Apron's
Bushing
Block
using
four Screws
(#56). Attach
the
assembled Top Slat Boards to the Side Aprons (#1) using two
Brackets (#63) and four Screws (#57) per Bracket.
See Fig.
3C.
Peel the protective film off the Z-Channels (#37), then peel the
other side backing off the underside of the Z-Channels (#387).
Turn them over and carefully place them along the inside bushing
bock on the inner Side Aprons.
See Fig. 3D.
©2010 Sportcraft, Lid.
www.sporterafi.com
Publicidad
