Descargar Imprimir esta página

RedMax HEZ230S Manual De Instrucciones página 5

Publicidad

Idiomas disponibles

Idiomas disponibles

HEZ230S
3. Warning labels on the machine
( 3 )
( 1 )
( 2 )
( 4 )
( 5 )
( 6 )
( 7 )
( 8 )
( 9 )
( 10 )
( 11 )
4. Symbols on the machine
For safe operation and maintenance, symbols are
carved in relief on the machine. According to these
indications, please be careful not to take a mistake.
(a) The port to refuel the "MIX GASOLINE"
Position: FUEL TANK CAP
(b) The direction to close the choke
Position: AIR CLEANER COVER
(c) The direction to open the choke
Position: AIR CLEANER COVER
US-4
Symbols
(1) WARNING! Edgers can be dangerous! Careless
or incorrect use can result in serious or fatal
injury to the operator or others. It is extremely
important that you read and understand the
contents of the operator's manual.
(2) Please read the operator's manual carefully and
make sure you understand the instructions
before using the machine.
(3) Max. speed of output shaft, rpm
(4) Always wear:
• A protective helmet where there is a risk of
falling objects
• Approved hearing protection
• Approved eye protection
(5) Always wear approved protective gloves.
(6) Wear sturdy, non-slip boots.
(7) Watch out for thrown objects and ricochets.
(8) Warning for rotating blade. Keep hands and feet
clear.
(9) WARNING! The-blade continues to rotate even
after the engine has stopped When the engine
has stopped, stop the blade from rotating by
letting the blade from rotating by letting the blade
come in contact with the ground.
(10) The operator of the machine must ensure, while
working, that no persons or animals come
closer than 15 meters.
(11) Arrows which show limits for handle
positioning.
IMPORTANT
If warning label peel off or become soiled and
impossible to read, you should contact the
dealer from which you purchased the product
to order new labels and affix them in the
required location(s).
WARNING
Never modify your machine.
We won't warrant the machine, if you use
the remodeled machine or you don't
observe the proper usage written in the
manual.
■ EMISSION CONTROL
An emission control label is located on the engine.
*1: The year will be changed every year of manufacturing.
*2: The first letter of the family name will be changed every year of
manufacturing.
*3: SP : Sealed tank made of HDPE or PE.
2015

Publicidad

loading