Descargar Imprimir esta página

BOMANN DR 435 CB Instrucciones De Servicio/Garantía página 26

Ocultar thumbs Ver también para DR 435 CB:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
4....-05-DR 2751
GB
Read the operating instructions carefully before putting the appliance into ope-
ration and keep the instructions including the warranty, the receipt and, if possi-
ble, the box with the internal packing.
The appliance is designed exclusively for private use and for the envisaged pur-
pose. This appliance is not fit for commercial use. Do not use it outdoors (except
if it is designed to be used outdoors). Keep it away from sources of heat, direct
sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the
appliance with wet hands. If the appliance is humid or wet, unplug it immediate-
ly. Do not put it in water.
When cleaning or putting it away, switch off the appliance and always pull out
the plug from the socket (pull on the plug, not the cable) if the appliance is not
being used and remove the attached accessories.
Never leave the appliance unsupervised. To protect children from the dangers
posed by electrical appliances, make sure that the cable is hanging low and that
children do not have access to the appliance.
Check the appliance and the cable for damage on a regular basis. Do not use
the appliance if it is damaged.
Do not try to repair the appliance on your own. Always contact an authorized
technician. To avoid the exposure to danger, always have a faulty cable be
replaced only by the manufacturer, by our customer service or by a qualified
person and with a cable of the same type.
Use only original spare parts.
Pay careful attention to the following "Special Safety Instructions".
Never place the device in the vicinity of e.g. walls or curtains during use.
Please do not place the machine on metal surfaces (e.g. sink).
The machine must always be switched off before the mains lead is removed.
Never immerse the lid of the food dehydrator in water.
Remove any packaging and transport safety equipment from the device, if pre-
sent. All parts should be rubbed down with a damp cloth. This will remove dust
which might have collected during transport. Re-insert the parts in the reverse
order.
Insert the mains plug into a correctly installed 230 V, 50 Hz safety power socket.
For the relevant information please see the type plate on the device.
Ensure that the machine is switched off.
Place the machine on the dry, non-slip surface.
26
21.05.2002 9:34 Uhr
General Safety Instructions
Special Safety Instructions
Before Initial Use
Seite 26

Publicidad

loading