H.Koenig UP370 Manual De Instrucciones página 11

MAINTENANCE
1. HV Mesh(Figure10)
After cleaning the dirt cup as figured above, HV mesh and metal filter can be cleaned at the
same time. Lift the HV mesh by hand, then beat it lightly to fall off the dirt on it. If the HV
mesh is very dirty, please clean it with water. After airing then can use. HV Mesh is replaced
by a new one every six months normally.
HV MESH
2. Brushroll After the brushroll working for a long time,there are too much hairs etc
foreign object into the roll, the brushroll will stop to run. Please clean and maintain the
brushroll: put down the vacuum cleaner,carry out the motorized brush,pull the brushroll
cover from the outer side by hand which showing in figure 11.Then use the blade or
scissors clean the brushroll slot(figure12)and clean the hair object. After finishing clean
the object,please take the brushroll fix into the motorized brush,then assembly it into the
main body.