Publicidad
Idiomas disponibles
Idiomas disponibles
Re-attaching theFridge Door
To re-attach
the fridge door, replace parts i n
reverse
order,
Re-attaching theFreezer Door
To re-attach
the freezer door, replace parts i n
reverse
order,
Re-attaching
the Water Supply Lines
1. The Water Lines must be fully inserted into the
center of the transparent coupler to prevent
water leakage from the dispenser.
2. insert the 2 clips in the install pack as shown
below, and then confirm that each clip holds
the line firmly,
Center of Transparent
coupler
Clip A (1/4")
(6,35 ram)
z_ CAUTION
Make sure the color of the water lines match,
Keep the clips out of the reach of children and
make sure that children do not play with them
or put them into their mouths,
LEVELING
THE REFRIGERATOR
Make sure the refrigerator is level so that you can
make final adjustments.
Use a level to test if the refrigerator is level both
side to side and back to front,
if the refrigerator is not level, you will not be able
to get the doors perfectly even, which may cause
moisture condensation
and increased energy bills,
[_
he front of the refrigerator is also
adjustable,
Before levelling the refrigerator,
remove
the front leg cover.
Open both the freezer and refrigerator doors.
Unscrew the three screws holding the front leg
cover in place by turning them counter-clockwise.
When the screws are loose, remove the front leg
cover,
When the Freezer part is lower than the
Fridge part.
insert a flat-blade screwdriver into a slot on the
Freezer Leg, then turn it clockwise,
When the Fridge part is lower than the
Freezer part.
insert a flat-blade screwdriver into a slot on the
Fridge Leg, then turn it clockwise.
Screw Driver
Leg
[_
efer to the next section for the best way
to make very minor adjustments to the
doors,
Engl sh --15
Publicidad
