FLYLINKTECH CF800 Manual Del Usuario página 8

1.Plug the usb cable into computer or any USB 2A wall adaptor (not included)
2.Connet the UCB C cable onto the Jump starter
Note: It is recommended to recharge the Jumpstarter every 3-4months to maintain efficiency and prolong the
service life of the internal battery even if the unit has not been used.
Charging your Devices
Use the original manufacturer's USB cable that came with your device and plugs it into one of the USB output
ports. You can charge two devices at the same time. One of the ports has a maximum output of 9V/2.4A while the
other has a maximum output of 5V/2.4A.The power level indicator will show the battery level. To check the power
capacity again, simply press the power button once.
Jump starting a Car
To jump-start the vehicle battery put the vehicle in park(neutral if the vehicle
has a manual transmission)and engage the emergency brake. Locate the
battery for the vehicle and follow the steps listed below.
Jump cables are color-coded, RED for POSITIVE(+)and BLACK for
NEGATIVE(-). Do not mix up the cables or allow the metal ends to touch
together because this may damage the battery, charging system, and/or
electronics on a vehicle.
5