Slope adaptor
hanger ball
Safety Pin
Downrod
Coupling cover
Fig. 11
Hanger
bracket
Fig. 12
3/16" X 65 mm
Safety pin
Fig. 13
. Slip the coupling cover, mounting screw cover and
canopy onto the downrod in the order shown. (Fig. 11)
7. Thread the Slope Adaptor Hanger Ball onto the
downrod until the Safety Pin center hole on the Ball
aligns with the safety pin hole in the downrod. Insert
the safety pin (careful not to damage the lead wires.)
(Fig. 11)
Canopy
NOTE: The Hanger Ball can be installed in ONLY one
Canopy cover
direction. The "cutout" should be toward the
"Lower" end of the ceiling slope. (Fig. 12)
8. Now lift the motor assembly into position with the
hanger ball in the position (shown in Fig. 13) and
place the pivot pens on the hanger ball into the pivot
groves on the hanger bracket. (Fig 12)
Next, lower the hanger ball until the pivot pens rest in
the bottom of the pivot groves. (Fig 12)
9. Make sure the Safety Pen installed in Fig 12 is
installed but NOT tightened. (Fig 13)
DO NOT TIGHTEN AT THIS TIME
Hanger
bracket