Publicidad
Idiomas disponibles
Idiomas disponibles
Hex nuts
Hanger
bracket
Fig. 14
Screws
Fig. 15
Hex nuts
3/16" x 65mm
Safety Pin
Hanger
bracket
Screws
Canopy
Canopy cover
FINISHING THE INSTALLATION
1. Now, rotate the "entire fan and slope adaptor
assembly" (left or right) by rotating the hanger
bracket until the downrod and the ceiling fan
assembly are hanging straight down and the entire
assembly "swings" freely in the exact direction of the
ceiling slope. (Fig. 14)
2. Now, Securely tighten the two (2) Hex Nuts
holding the hanger bracket to the mounting plate.
Making sure the Hanger Bracket is secure and can
not move. Next, securely tighten the 3/16" x
65mm Safety Pin. (Fig. 14)
3. Make all necessary electrical connections by
referring to your ceiling fan installation manual.
Next, tuck all lead wires neatly into the opening
above the hanger ball.
4. Slide the canopy up to the ceiling and place the
mounting screws through the key holes in the face of
the canopy. Rotate canopy clockwise. (Fig. 15)
Next, while holding the canopy with one hand, slide
the mounting screw cover onto the heads of the
mounting screws and rotate clockwise until tight.
If necessary, adjust the canopy screws until the
canopy and mounting screw cover are snug.
Publicidad
