Publicidad
Idiomas disponibles
Idiomas disponibles
CHARGING
1) Flip over the rubber cover to unveil the USB Type-C charging port. Connect USB
Type-C cable to the charging port.
2) The charging speed depends on what adapter is used. It is suggested to use an
adapter supporting Type C (5V/2A) to fully charge in approximately 4 hours.
3) During charging, the power indicator flashes in green slowly. When the green light
stops flashing, the device is fully charged.
4) The power indicator shows the battery level:
a) Flashing Red Light: 0-10%
b) Flashing Green Light: 10-99%
c) Solid Green Light: 100%
OPERATING - HOT STONE MASSAGE WAND
1) Switch the control clockwise once to power on the device. Switch the control
repeatedly to adjust the temperature setting during operation. Switch clockwise
for higher temperatures, and anti-clockwise for lower temperatures or power off.
2) The temperature indicator indicates the corresponding heat level.
Level 1 (yellow light, 45 degrees Celsius)
Level 2 (orange light, 50 degrees Celsius)
Level 3 (red light, 55 degrees Celsius)
Level 4 (white light, 60 degrees Celsius)
3) Always start with level 1 for first-time use.
4) After switching on for 1 minute, the wand(s) will be warmed up and ready to use.
5) Place the hot stone wands either on arms, shoulder, neck, back, abdominal,
buttock, legs, or feet of your partner or yourself and apply the 7 massage skills to
enjoy hot stone massage treatment.
6) Apply a small amount of massage oil on the skin or on the wand when lubrication
is needed.
7) Switch the control anti-clockwise once during Level 1 to power off the device.
8) When the battery level is lower than 10%, the power indicator flashes in red. The
device will turn off in 3 minutes. Please recharge the battery.
Publicidad
