Casals MT300EK Instrucciones De Uso página 9

also be bought separately from the Technical
Assistance Service.
FITTING SAFETY DEVICES
Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Take special care about the accessories. They
may be stored and used according to the
manufacturer's instructions.
Do not use the appliance if the accessories
or consumables attached to it are defective,
Replace them immediately.
FITTING THE ACCESSORIES
If an accessory is assembled, loosen the screw
(I) using the Allemn wrench (K)
Mount the accessory (F or G) on the tool
holder (E). The pins of the tool holder must
engage in the openings of the accessory.
For a more confortable work you can mount
the accessories (F or G) in any snap-in position
on the tool holder.
Fasten the accessory on the tool holder.
Tighten the screw and the nut on the tool
holder with the allen wrench.
Check the accessory is securely and strongly
fastened.
FITTING THE SANDING PAD
Mount the accessory on the tool holder. The
pins of the tool holder must engage in the
openings of the accessory.
Fasten the accessory on the tool holder.
Tighten the screw and the nut on the tool
holder with the allen wrench.
Check that sanding pad is securely fasten.
WARNING: The holes on the used sand paper
need to fit the holes on the sanding pad for
a proper functionality of the dust collection
system.
INSTRUCTIONS FOR USE
BEFORE USE:
Ensure that the voltage indicated on the
rating label matches the mains voltage before
plugging in the appliance.
USE:
Prepare the appliance tto the function you want
to develop.
Connect the appliance to the mains.
Turn the appliance on, by using the on/off
switch (A).
ELECTRONIC SPEED CONTROL:
The speed of the appliance can be regulated
by using the speed regulator control (B). This
function is very useful, as it makes it possible
to adapt the speed of the appliance to the type
of work that needs to be done.
CAUTION: If the appliance continuesly works
at low speed, working life of the appliance will
be severly reduced.
SAWING
Always check the workpiece before operation
and remove any obstructions such as nails,
staples, screws, strings, rags and other debris.
Plunge cutting is only allowed in soft materials
such as wood or plastic boards.
Apply light and uniform pressure to obtain a
suitable result.
SANDING
Apply light and uniform pressure to obtain a
suitable result.
SCRAPING
Select a high-speed rate.
Apply light and uniform pressure to obtain a
suitable result.