Publicidad
Idiomas disponibles
Idiomas disponibles
Step 2: Clean up
1.Remove the water box itself, and the water box cover, the seal ring and the
water valve elements
2.Clean up the elements of the water box with cold or warm water.
3.Wipe out the water with dry cloth
Notes:
1.If you clean the water dispenser by cleaning solution, you had better put the
box to its originally position, and drain 5 to 6 cups of water out, then you can
use it normally, in case that there is remaining dirt of application instruction.
Step 3: Installation
1.Installation of water valve elements
Put the guide projecting platform directed to the guide groove,
after that, push it downside with 45?slantly at full tilt, until you
hear a crack
2.Installation of seal ring of the water box
Put the seal ring to the bottom of the water box, and be sure
that the seal ring is in place. Avoid that wrinkle seal ring or in
wrong place.
3.The Installation of water box elements
To keep the hanging slot of the water box elements direct to
the hangers on the door liner. The seal ring at the bottom of
the box shall directed to the entrance of the water valve
elements, insert it to the corresponding position along with
the 45°slantly
15
Publicidad
