Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning and Care
Interface MUST be installed inside the steam room for proper operation of the system. Use a damp cloth and mild
soap to clean the interface. Do NOT use abrasive cleaners which might scratch the interface.
The 8CN-600S, 8CH-600S and 8CB-600S interfaces will only function with 8GE-TSG steam generator models.
1
Pre-Installation - Interface Location
The 8CH-600S, 8CB-600S and 8CN-600S Series Digital Interfaces must be installed inside the steam room and
away from the steam head (opposite wall preferred). For convenience the recommended height from the floor is
four feet. Provide a 2 3/4" hole in the wall at this location (see Figure 1).
Figure 1
IMPORTANT: Run the
interface cable through
a ¾" conduit.
Required Inside Instal-
lation. Locate away
from the direct line
of shower spray and
do NOT locate above
steam head. Opposite
wall from steam head
is preferred.
located four feet
Important: The steam generator required to complete installation ships with a 35' cable. When connecting an
8CH-600S, 8CB-600S or 8CN-600S Series Digital Interface, the 8GA-000 power booster will be required for any
installation where the cable or combination of cables exceed 35 feet (to a maximum of 70 feet). The power booster
and alternative length cables are available for purchase separately.
2 3/4" Hole
from the floor
Double-Sided
Adhesive Pad
To Steam Generator
Coupler
3
113040 Rev. C
Publicidad
