Publicidad
Idiomas disponibles
Idiomas disponibles
Moving
the Appliance
for
Servicing
and Cleaning
Turn off the range line fuse or circuit breakers at the
main power source, and turn off the manual gas shut-off
valve. Make sure the range is cold. Remove the service
drawer (warmer drawer on some models) and open the
oven door. Lift the range at the front and slide it out
of the cut-out opening without
creating undue strain
on the flexible gas conduit. Make sure not to pinch
the flexible gas conduit at the back of the range when
replacing the unit into the cut-out opening. Replace
the drawer, close the door and switch on the electrical
power and gas to the range.
Range Installation
Important
Note: Door removal is not a requirement for
installation of the range, but is an added convenience.
Refer to the Use and Care Guide for oven door removal
instructions.
Standard
Installation
The range cooktop
overlaps the countertop
at the
sides and the range rests on the floor. The cooktop is
311/2" (80 cm) wide.
Install base cabinets 30" (76.2 cm) apart. Make sure
they are plumb and level before attaching
cooktop.
Shave raised countertop
edge to clear 311/2" (80 cm)
wide range top rim.
To provide an optimum
installation,
the top surface
of the countertop
must be level and flat (lie on the
same plane) around the 3 sides that are adjacent to
range cooktop. Proper adjustments to make the top
flat should be made or gaps between the countertop
and the range cooktop may occur.
To reduce the risk of damaging your
appliance,
do not handle or manipulate
it by the
cooktop. Manipulate with care.
Position range in front of the cabinet opening.
Make sure that the underside of the cooktop
clears
the countertop. If necessary, raise the unit by lowering
the front leveling legs and the back leveling wheels.
Level the range
(see section 9). The floor where
the range is to be installed must be level. Follow the
instructions under "Leveling the Range".
Slide the range into the cutout opening.
If Accessories
Needed
:
Installation
With Backguard
The cutout depth of (21 3/4" (55.2 cm)Min., 22 1/8"
(56.2cm) Max.) needs to be increased to 24" (61 cm)
when installing a backguard.
Installation
With End Panel
A End Panel kit can be ordered through a Service
Center.
Installation
With Side Panels
A Side Panels kit can be ordered through a Service
Center. Note: Install cabinet doors 31 " (78.7 cm) min.
apart so as not to interfere with range door opening.
Install cabinet doors 31 " (78.7 cm) min. apart so as
not to interfere with range door opening.
Cutout countertop exactly as shown on page 1.
Make sure the four leveling
legs are setup higher
than the height of the cabinet (shown on page 3).
Install
the
anti-tip
bracket
at
this point
before
placing
the range at its final
position,
Follow the installation instructions on page
13 or on the anti-tip bracket template supplied
with
the range.
10
Publicidad
