IRUDEK BOREAS Manual De Uso página 23

short descent heights will wear the rope. Wear is also induced
by other factors such as maintenance, sharp edges, chemical
and mechanical influences, etc.
Abrasion and wear should be checked regularly. If the rope
does not appear to be secure, send the device to Irudek or
an authorised person for inspection and replacement of the
rope.
INFORMATION ABOUT THE WORK ACCORDING TO EN
341:2011 -1A
Working capacity: 7 500 000 joules
Work W = m x g x h x n
• W = work in Joules(J)
• m = load capacity (weight of person) (kg) g = gravity 9.81
m/s#.
• h = height of descent in metres(m)
• n = number of descents
POSSIBLE INFLUENCING FACTORS
• Extreme conditions of use
• Mechanical and chemical damage
• Environmental factors
• Inadequate storage and transport
MAXIMUM RECOMMENDED LIFTING DISTANCE
During lifting, the descent device and the rope are subjected
to greater stress than during descent. Frequent use of the
lifting function can cause slipping. Normally, this is not
dangerous and it is safe to descend to the ground. However,
the maximum lifting distance should not exceed 4 times the
length of the rope. Be sure to check the abrasion of the rope
accordingly.
WARRANTY
The warranty for this product is 3 years, limited to
manufacturing and raw material defects. It does not cover
deterioration, corrosion and damage caused by improper or
intensive storage, transport or use.
The warranty request must be accompanied by proof of
purchase. In the event of a manufacturing defect, IRUDEK
undertakes to repair, replace or pay for the product, without
exceeding the invoice price of the product.
STORAGE
This personal protection system must be stored in a package
with plenty of room in a dry place, protected against sunlight,
ultraviolet rays, dust, sharp objects, extreme temperatures
and a ressive substances.
TRANSPORT
This personal protection equipment must be transported
in packaging that protects it against humidity and any
mechanical, chemical and/or thermal damage.
MAINTENANCE AND CLEANING
• Repairs must only be carried out by Irudek or an
authorised partner.
• If this product has been subjected to a fall, all parts must
be inspected and, if necessary, replaced.
• This product should not be tumble dried, dried in the sun
or on a heat source (e.g. a radiator). Air dry this product
in a shaded and ventilated area.
• This product (the rope in particular) must not be
disinfected with chemicals.
• Do not use chemicals to clean the product.
• This product must be inspected by or an authorised
partner at least once a year, but in any case after the
maximum descent distance. Note the distance in the
protocol of use.
REPAIRS
Product changes:
• Unauthorised repairs, adjustments or changes to this
product may result in serious accidents and falls.
• Changes (e.g. changing the rope length) and repairs have
to be carried out by Irudek.
• If you are unsure whether this product can still be used,
do not use it and send it to Irudek or an authorised partner
for inspection.
Cleaning:
• Clean the metal parts with a damp towel.
• Never tumble dry in the dryer, in the sun or over a heat
source.
• Air dry this product in a ventilated and shaded area.
• Rinse the rope with lukewarm water and then wipe it with
a dry towel.
• Never disinfect the rope
• Never use chemical detergents.
Disinfection of this product is prohibited. In case of
contamination, remove this product from the environment.
EN 21