Taurus GF52IXAL Manual Del Usuario página 13

 To install the carbon filters, remove the grease
filters as explained above, plug the filters into
the unit and turn them clockwise on both sides
of the motor, as shown below:
 Make sure the filter is securely locked.
 NOTE: When the carbon filter is connected, the
suction will be lower.
MODES
 The device has 2 installation modes:
Recirculation mode and extraction mode.
EXTRACTION MODE:
 The extraction mode expels the air to the
outside. This mode guarantees high
performance, high capacity and low noise level.
RECIRCULATION MODE:
 The recirculation mode removes odours by
means of a carbon filter and reintroduces the
air into the kitchen. This mode is suitable for
rooms without extraction ducts, saves air and
prevents thermal losses to the outside.
 For this mode, you need to obtain the carbon
filters and install them as explained in the
installation part, they are not included.
INSTRUCTIONS FOR USE
BEFORE USE:
 Remove the appliance's protective film.
 Make sure that all products' packaging has
been removed.
 Ensure that the selected tension on the voltage
selector coincides with the tension of the
mains.
USE:
 Connect the appliance to the mains.
 Pull the telescopic tray.
 Turn the appliance on, by using one of the
speed selection buttons (Fig.2).
LIGHT FUNCTION:
 The appliance includes a light function, which
illuminates the working area under the
appliance (Fig.2).
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
 Stop the appliance by pressing the stop button
(Fig.2).
PRACTICAL TIPS:
 It is recommended to keep the filters clean,
grease and dirt in the filters decreases the
efficiency of the engine and increases its
energy consumption.
 Adjust the extraction speed according to the
amount of smoke, working at high speeds with
little smoke consumes more energy.
CLEANING
 Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
 Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
 Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
 Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
 Never submerge the appliance in water or any
other liquid or place it under running water.
 If the appliance is not maintained in good
cleaning condition, its surface can degrade and
E N