Descargar Imprimir esta página

Garland BOLT 725 QG Manual De Instrucciones página 37

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Tighten, repair or replace everything you need to
before using the machine. Do not use any accessory
on this machine outside of those recommended by us
since its use could cause serious damage to the user,
the machine and people, animals and things close to
the machine.
NOTE: This machine has an oil sensor to prevent
the engine from starting with an oil level below the
recommended minimum. If the oil level is too low the
engine will not start.
6.5.2. PLACEMENT OF THE MACHINE
Make sure that you install the machine in a stable
position.
Connect a cable from the ground
generator grounding.
6.5.3. START-UP
Follow the start-up procedure in cold or hot depending
on the condition of your engine.
6.5.3.1. STARTING THE MOTOR IN COLD
• Place the machine on a flat, stable surface to start it.
• Place the circuit breaker in alternating current (AC)
in the OFF position.
• Place the faucet of the fuel in the open position
(ON)
• Place the choke in closed air position
• Set the switch of the motor to the on position (ON).
• Hold the machine by casting so it doesn't move
from its position on the floor when pulling the
starter rope.
• Pull the starter rope until the engine starts.
• If the machine starts and doesn't stop gradually
changing the air level position
• Let the engine warm up for a few minutes before
using the machine.
6.5.3.2. STARTING THE MOTOR HOT
• Place the machine on a flat, stable surface to start.
• Place the circuit breaker in alternating current (AC)
outlet of
in the OFF position.
• Place the fuel tap in the open position (ON).
• Place the choke in the normal working position
(open position RUN).
• Set the switch of the motor in position (ON).
• Hold the machine by the handle so it doesn't move
from its position on the floor when pulling the
starter rope.
• Pull the starter rope until the engine starts.
• If after a few attempts the machine does not start
follow the steps in the engine starting.
6.5.4. STOPPING THE MOTOR
• Stop the engine by moving the engine switch to the
OFF position.
• Place the tap of the fuel in the closed position
(OFF).
37/120
English
(CHOKE).
(air open RUN).

Publicidad

loading

Este manual también es adecuado para:

Bolt 925 qg