Publicidad
Idiomas disponibles
Idiomas disponibles
CARE AND MAINTENANCE
TROUBLESHOOTING
GUIDE
Occasional
care and maintenance
of the unit and the software
If the unit fails
to perform
as described
in these
Operating
are nseded
to optimize
the performance
of your unit.
Instructions,
check the following
guide.
To clean the cabinet
GENERAL
Use a soft and dry cloth.
There is no sound.
If the surfaces
are extremely
dirty,
use a soft cloth
lightly
Is the AC cord connected
properly?
moistened
with
mild detergent
solution,
Do not use strong
Is there a bad connection?
(+ page 3)
'
solvents,
such as alcohol,
benzine
or thinner
as these
could
There may be a short circuit in the speaker
terminals,
dama,ge the finish of the unit.
+
Disconnect
the
AC
cord,
then
correct
the
speaker
connections,
TCIclean the heads and tape paths
Was an incorrect
function
button pressed?
After every
10 hours of use, clean the heads
and tape paths
Sound is emitted from one speaker only.
with a head cleaning
cassette
or cotton
swab moistened
with
Is the other speaker
disconnected?
cleaning
fluid or denatured
alcohol.
(These
cleaning
kits are
The output sound is not stereo.
commercially
available.)
IS the Karaoke
function
turned on? (+ page 17)
When cleaning
with a cotton swab, wipe the recording/playback
An erroneous
display or a malfunction
occurs.
%
head, erasure
head (deck 2 only), capstans,
and pinchrollers.
+
Reset the unit as stated below,
#——
%
After
cleaning
the heads
and tape
paths
with a liquid
head
cleaning
cassette
or a moistened
swab, wait until the cleaned
parts are completely
dry before inserting
the tapes.
To demagnetize
the heads
The Iheads may become
magnetized
after long-term
use.
This
may narrow
the output
range of recorded
tapes
and increase
noise.
After 20 to 30 hours use, demagnetize
the heads with
any commercially
available
demagnetizer,
TUNER SECTION
There is constant, wave-like
static.
c Is
the antenna
connected
properly?
(+ page 4)
Is the signal weak?
+
Connect
an outdoor
antenna.
The reception contains
noise interferences
or the sound
is distorted.
Is
the system picking up external
noise or multipath
distortion?
+
Change
the orientation
of the antenna,
+
Move the unit away from other electrical
appliances.
CASSETTE
DECK SECTION
The tape does not run.
Is deck 2 in pause mode?
(+ page 10)
The sound is off-balance
or not adequately
high.
Is
the playback
head dirty? (+ page 22)
Recording
is not possible.
Is
the erasure
prevention
tab on the tape broken off? (+ page
1
o)
[s
the recording
head dirty? (+ page 22)
Erasure is not possible.
Is
the erasure
head dirty? (+ page 22)
Is a metal tape being used?
High frequency
sound is not emitted.
Is
the recording/playback
head dirty? (+ page 22)
Care of discs
CD PLAYER SECTION
When a disc becomes
dirty, wipe the disc from the center out
The CD player does not play.
with a cleaning
cloth.
Is the disc correctly
inserted?
(+ page 11)
Is the disc dirty? (+ page 22)
IS the lens affected
by condensation?
+ Wait approximately
one hour and try again
e Aftlsr playing
a disc, store the disc in its case. Do not leave the
disc in places that are hot or humid,
Care of tapes
,
*
Stc]re tapes in their' cases after use.
e Do not leave tapes near magnets,
motors,
television
sets, or
any source of magnetism.
This will downgrade
the sound quality
and cause noise.
o
Do not expose
tapes to direct sunlight,
or leave them in a car
parked
in direct sunlight,
To reset
If an unusual
condition
occurs
in the display
window
or the
cassette
decks, reset the unit as follows.
1
Press the POWER
button to turn off the power.
2
Press the POWER
button
to turn the power
back on while
pressing
the
CLEAR
button.
Everything
stored in memory
after purchase
is canceled.
If the power cannot be turned off in step 1 because of a malfunction,
reset by disconnecting
the AC cord, and connect
it again. Then
repeat step 2.
ENGLfSH
22
Publicidad
