Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
1.
Find a suitable location for the Hybrid Repeater.
Place the repeater in a convenient and accessible
location. Note: Hybrid Repeaters must be within 60
feet (18 m) of an RF Processor or another repeater
when using the RF Link for repeater-to-repeater or
repeater-to-processor communication.
2.
Connect Hybrid Repeater Link (if applicable).
Connect the Hybrid Repeater Link communication
wires from the HomeWorks
Hybrid Repeater in the daisy chain) to the terminal
block on the Hybrid Repeater (see Wiring
Diagram). Each terminal will accept up to three
22-18 AWG (0.5-1.0 mm
Note: If using the plug-in adapter to power the
repeater, DO NOT connect the +15 V terminal
(terminal 2).
3.
Apply power to the Hybrid Repeater. If the
Hybrid Repeater is to be powered by the Hybrid
Repeater Link, apply power by turning on the
HomeWorks Processor. If the Hybrid Repeater is to
be powered by the plug-in adapter, insert the
adapter cord plug into the jack on the Hybrid
Repeater, then plug the adpater into a standard
wall receptacle.
STATUS and
TEST LEDs will
be dimly lit when
first powered
Plug in
adapter jack
Wiring Diagram
HR-REP
(Side View)
4
MUX
3
MUX
2
+15 V
1
COM
2
Processor (or previous
®
2
) wires.
Plug in
power cord
and adapter
(optional)
Wall Mounting
Hybrid Repeaters may be wall mounted using the
supplied wall bracket.
1.
Attach wall bracket to wall using the supplied
screws and wall anchors.
UP
2.
Place power cord into notches at top and bottom of
wall bracket. Wrap excess power cord around the
cord holder. Route Hybrid Repeater Link wiring
through hole in wall bracket and out through side
cutout. Align repeater and snap onto wall bracket.
Hybrid
Power Cord
Repeater Link
Wiring
UP
Operation
RF TX/RX LEDs
WIRED TX/RX LEDs
Indicate RF Link
Indicate Wired Link
activity.
activity.
TEST LED
A slow flash indicates
RF communications
tests are in progress
STATUS LED
Indicates the status of the HomeWorks
system.
Note: When the Hybrid Repeater is
powered, but has not yet been assigned
an address from the HomeWorks
Illumination Software, the STATUS and
TEST LEDs will be dimly illuminated.
STATUS Button
Used when addressing the
Hybrid Repeater from the
HomeWorks Illumination
TM
Software.
TEST Button
Activates RF communication
tests. To activate the tests,
press and hold the TEST
Button until the TEST LED
begins to flash.
Note: For communication tests,
the Hybrid Repeater,
HomeWorks Processor, and
other RF devices must first be
configured and addressed
using the HomeWorks
Illumination Software.
Publicidad
