Publicidad
Idiomas disponibles
Idiomas disponibles
Control panel functions
To operate the MS Avicleaner correctly, it is important that it is clear what all levers and buttons are for.
The ''primary control panel'' section on the previous page shows an overview of where all the buttons and
levers are on the MS Avicleaner, and this section explains everything.
1. Emergency stop:
There is an emergency stop on the machine for when the machine has to stop driving/moving suddenly,
when the emergency stop is pressed everything is switched off.
When the emergency stop has been pressed and you want to use the MS Avicleaner again turn and pull the
emergency stop at the same time, after you hear a click sound you can use the machine again.
2. Height adjustment of the cleaning module:
The MS Avicleaner must operate at different heights, that is why there is a lever that allows to set the exact
height. This lever is located on the left side of the control panel.
3&4. Tracks control left/right side:
To operate the tracks separately, two separate levers are provided on the control panel of the MS
Avicleaner. Moving the lever forward will move the machine forward. If you move the lever to the back it will
move backwards.
5. Operation of water:
In order for the MS Avicleaner to actually clean there is a large lever to operate the water. When you pull it
backward, the water is activated and cleans the MS Avicleaner. You can hold this lever backwards with your
hands while driving, to do so hold the handle keep the lever pulled backwards.
6. Selector for tracks speed:
The selector is used to control the speed of the MS Avicleaner. Lever pushed to the left is slow, right is fast.
This can be recognized by the symbols ''turtle'' and ''hare.''
35
Publicidad
