Publicidad
Idiomas disponibles
Idiomas disponibles
Make the adjustment using the following steps:
NOTE
Carry out the adjustment of the carburetor with the string attached.
1.
H and L needles (high and low) are restricted in number of turns, as shown below.
Needle "H" - ¼
2.
Start the engine and leave heating on medium speed.
3.
Turn the adjustment screw idle (T) to the left so that the chain does not move the greencut.
If the idle speed is too low, turn the screw clockwise.
4.
Make a test cut and adjust the needle H (high) for greater cutting power, not for maximum
speed.
CHAIN BRAKE
This equipment is equipped with an automatic brake that stops the rotation of the saw chain when
a kickback occurs during the operation of this. The brake is actuated automatically due to the inertia
force acting on the weight existing within the shield when the backlash occurs. You can manually
operating the brake by pushing the front hand guard towards the side of the guide bar. It can be
operated manually by pushing the brake shield to the side of the handle.
NOTE
Be sure to check the brake operation when performing routine inspection.
Verification method:
1. Stop the engine.
2. Hold horizontally chain saw with two hands, release the hand of the front handle, hit the tip
of the guide bar against a stump or something similar, and check that the brake is working
properly. The height of operation depends on the size of the bar.
If the brake is not working properly, request an inspection and repair your dealer. Avoid running the
engine at high speed with the brake engaged as esoresulta heats the clutch and failure of product.
When the brake operates during operation of the mountains, immediately release the throttle lever
and stop the engine.
Needle "L" - ¼
99
EN
Publicidad
