Descargar Imprimir esta página

Greencut GM56LI-ION 4-1 Manual De Instrucciones página 108

Publicidad

Idiomas disponibles

Idiomas disponibles

108
TO ADJUST THE SAW CHAIN TENSION:
1. Loosen the bar retaining nuts so they are hand tight.
2. Holding the nose of the bar up, use the screwdriver to turn the guide bar adjustment screw
clockwise to tighten the chain. Turning the screw counterclockwise loosens the chain on the
guide bar.
3. While wearing heavy duty work gloves (alter you've made the adjustment), move the saw
chain back and forth on the guide bar to be sure the chain moves freely and is in proper mesh
with the sprocket. Never move the chain with your bare hands.
NOTICE
lf the chain is difficult to rotate or if it binds on the guide bar, there is too much
tension applied and it must be adjusted. To decrease tension, turn the adjustment
screw counterclockwise, slowly. Move the chain back and forth until it moves freely.
4. Holding the nose in upper position, securely tighten the bar retaining nuts.
OILING THE CHAIN
The saw chain is self-lubricating. Oil is dispersad onto the chain as the unit is used. Keep an adequate
amount of oil in the oil tank. Always use bar-chain and sprocket oil or similarchainsawoil.
HEDGE TRIMMER
To enhance your tool add-on value, this product can be attached without any hassle:
1. Assemble the hedge attachment with the power head shaft (refer the assemble instruction
in the manual).
2. Refer the operating instruction in the user manual for the operation.
PREPARING FOR THE OPERATION
For the ease and safety of operation, your hedge
trimmer mus! be attached with loop type handle
trimmer.
For more properly clase to the area you are trimming,
you can adjust the blade angle based on the practica!
situation adjustment method as below: Press A & B at
the same time and then adjust the blade angle. Alter
adjusting, release A & B.

Publicidad

loading