Genius H7 Instrucciones De Uso página 27

Use of the fan heater
Initial start-up
NOTE!
For optimum heating performance, close doors and windows.
„
Place the fan heater at a sufficient distance from the walls and ceiling.
„
Keep textiles and other flammable objects away from the air inlet and outlet.
„
Turning the product on and off
Place the product on a straight and firm surface so that it cannot fall down. Always hold the product by
„
the carrying handle.
Insert the mains plug of the fan heater into the mains socket.
„
Flip the button on the lower back of the device.
„
Press the on/off button for a few seconds to switch on the fan heater. It starts in auto mode.
„
After a short measurement, the display shows the current room temperature.
„
Set the desired operating mode and speed using the buttons on the product or the remote control.
„
Press the on/off button for 3 seconds to switch off the unit. The unit switches off after 60 seconds.
„
After use, disconnect the appliance from the mains by flipping the switch on the bottom back panel.
„
Operation
The product can be operated either via the control panel or the remote control.
„
The display shows the current functions and settings during operation.
„
When operation is complete, the room temperature is displayed.
„
When operating by remote control, the remote control must be placed directly on the receiver
„
(display). For better reception, avoid direct sunlight on the receiver, e.g. by drawing the curtains.
Before using the remote control
„
remote control to put it into operation.
By pressing the mode button on the remote control
„
- Low and speed 2 - High.
Timer function
The timer function allows you to programme the product to start or stop heating automatically after a
„
time you set (1 to 8 hours).
You can interrupt the timer at any time and switch off the unit.
„
Setting the timer function via the appliance
Press the button until the desired number of hours flashes.
„
To turn off the timer, press and hold the button until the hour indicator on the display goes out.
„
Set the timer funciton via the remote control
Press the button on the remote control that indicates the desired time.
„
Instruction manual
for the first time, pull out the contact strip on the back of the
you can switch between speed 1
GB
27