cecotec CONGA ROCKSTAR 2500 TITANIUM ERGOWET Manual De Instrucciones página 24

ENGLISH
4. OPERATION
You can use this vacuum cleaner in two different manners:
- Handheld vacuum cleaner, attaching the accessories directly to the main body.
- Upright vacuum cleaner, using the vacuuming tube with the accessories assembled.
Using the vacuum cleaner
- Press the power button to turn the vacuum cleaner on or off.
- Press the speed dial repeatedly to select the device's operating speed: LOW, MED, HIGH
and AUTO. The device will turn on in LOW mode by default.
- If AUTO mode is selected, the vacuum cleaner will automatically adjust the suction power
based on dust concentration and surface type.
- When the battery shows a percentage equal to or less than 20 % while running at high
speed, the vacuum cleaner will start running at medium speed automatically to extend
the battery life.
Using the vacuuming brush head
- Press the power button to turn the vacuum cleaner on or off.
- Press the speed dial to set the power level to: LOW, MED, HIGH and AUTO.
- If you select the AUTO mode, the device will automatically adjust suction power according
to the concentration of dust and the type of surface.
- When operating at high speed and a battery at 20% or lower, the device will automatically
switch to medium speed to lengthen the battery life.
- The vacuuming brush head can remove dust from carpets, hard and soft floors, and tiles.
- If too many particles or fibres are vacuumed, or if a child touches the brush during
operation by accident, the rotary brush stops spinning automatically to prevent tangles
and possible damage.
Accessories
This device includes different accessories that allow cleaning different types of surfaces,
objects and dirt. Some of them are suitable for the upright vacuum cleaner, and others are
preferably used with the handheld one.
Jaliscazo brush
Assemble this brush to the upright vacuum cleaner. This brush is especially designed for
cleaning hard floors, but can be used to efficiently clean soft floors too.
2-in-1 narrow accessory for corners and furniture
Fig. 4
This accessory is preferably used with the handheld vacuum cleaner and allows cleaning
furniture without damaging it and reaching less accessible dirt in corners.
46
2-in-1 wide accessory for corners and furniture
Fig. 5
This accessory is preferably used with the handheld vacuum cleaner and allows cleaning
furniture without damaging it and reaching less accessible dirt in corners.
flexible vacuuming tube
Use the Flex tube to reach and vacuum dirt from the most inaccessible areas. Press the Flex
button to bend the tube.
Watertank accessory
With this accessory you will mop and scrub your floor by just attaching it to the vacuum
cleaner.
Wall charging base installation
Fig. 6
1. Place the charging base on the wall and mark 3 spots to be drilled to fix the base. You
must take into account at which height you install it; it is important that the vacuuming
brush head rests on the floor to avoid the charging base from holding all the vacuum
cleaner's weight.
2. Drill the 3 holes (previously marked) and insert the pegs and M4 x 32 mm screws.
3. Make sure that the charging base is securely fixed on the wall and place the vacuum
cleaner on the charging base by placing the vacuum cleaner charging terminals over the
charging base charging terminals (plastic tab).
4. Once the wall charging base is installed, connect the power adapter to the charging port,
and then you can charge the vacuum cleaner by simply sliding it up and down the wall
charging base. Fig. 7
Charge and display
- When the battery percentage is 20% or below, the device will automatically enter low
consumption mode. It is recommended to charge the vacuum cleaner when it reaches this
percentage.
- The battery must be charged with the charging base while it is connected to the main body.
Connect one of the ends of the power adapter to the power supply and the other to the
charging base. Fig. 7
- During charging, the charge light indicator will turn on red and the display will show the
current charge percentage. When the device is fully charged, the battery indicator will turn
green and the display will show 100%. Fig. 8
- You can also charge the battery without using the charging base. You can charge the
battery when the battery is installed or not in the vacuum cleaner. Connect the adapter and
connect the other end to the battery, paying attention to the direction. Once it is properly
connected, the charge light indicator will turn on red and will turn green once the charge
is complete. Fig. 9
ENGLISH
CONGA ROCKSTAR 2500 TITANIUM ERGOWET 47