Publicidad
Idiomas disponibles
Idiomas disponibles
M4M
POWER SUPPLY
4
1
1 MAINS INPUT
Power input socket on panel. Each package includes a power cord specific to the
country of use. With the monitor turned off, plug the power cord into this socket.
NOTE: the protection fuse is located inside the cabinet.
CAUTION: Do not attempt to open the cabinet to replace the fuse; contact an
authorised service centre.
BLUETOOTH
CONNECTION
®
5
- Check that the device to be paired with the monitor is powered on and ready for
connection via Bluetooth
. With the speaker powered on, hold the Bluetooth
®
pressed for a few seconds. The blue LED will flash.
- Check that M4M appears in the list of available devices on your smartphone/tablet.
- Select M4M to start the Bluetooth
pairing process. The blue LED illuminates steadily to
®
signal that the pairing process has been completed successfully.
(N.B. Once the first pairing process has been completed, it is sufficient to check
that the monitor and the mobile device both have Bluetooth
reconnect automatically on power up.
- Use the MAIN LEVEL control knob to adjust the output level to achieve the desired
listening volume.
14
button
®
activated for them to
®
QUICK SETUP
6
Place the speakers in the correct position
(right/left). With the power off, set the main
level to minus infinity.
Connect the audio source as required (RCA,
TRS balanced, 3.5 mm AUX IN, Bluetooth
).
®
To use a Bluetooth
source, enable pairing
®
and connection as described in the section
above.
User manual
Connect the passive speaker to the rear of
the active speaker using the 2-core cable
provided (red to red terminal, black to black
terminal).
Connect the power cord and turn on the
monitor.
Adjust the audio level for optimal listening
volume.
15
Publicidad
