Contest VPAR-70DW Guia Del Usuario página 19

VPAR-DW - IP66 architectural projectors with 7/12/18 Dynamic white LEDs
4 - Attaching the bracket and aiming the projector
Ø13
C
C
C
To choose the tilt angle of your projector: loosen the central screw using a 6mm Allen key and
rotate the projector. The notched clamping part allows the projector to be positioned permanently
and the marking of the angles provides information on the direction of the beam (see figure
opposite).
5 - Spoiler assembly
A
C
B
A
C
B
A
C
B
The projector can be fixed on a
suitable flat surface using three
attachment points A C C. The notch
B is used to lock the rotation of the
projector in Pan over 180°.
Temporary hanging is possible using
two clamps fixed through the external
holes C.
CAUTION !
Ensure that the anchor points are
properly tightened. Use 12mm stainless
screws and check the solidity of the
support. It is mandatory to install a
safety sling. When installing in a public
place, legislation requires each device
to have a double safety hook. This
security system must support 10 times
the weight of the device so you must
provide a sling capable of supporting
at least 35 kg minimum for the VPAR-
70DW, 55 kg for the VPAR-120DW and
70 kg for the VPAR-150DW.
The anti-glare spoiler is supplied
in the device packaging. It is fixed
using 4 screws on the front of the
projector.
English
Page 19