Publicidad
Idiomas disponibles
Idiomas disponibles
Adjust the desired inclination-angle via the mounting-bracket and tighten the fixation screws.
Before taking into operation for the first time, the installation has to be approved by an expert!
Connection with the mains
Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green
Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
OPERATION
Switch the device on via the power switch. Connect the remote control with the Remote Control-socket.
DANGER TO LIFE!
International
L
N
By operating the snow switch on the remote
control the snow emission starts. It may
happen that the stand-by lamp turns off and
the snow emission stops. In this case the
device is heating up again and will be ready to
operate in approx. 1-2 min. This process
guarantees
temperature and the best snow emission
possible. The temperature is regulated by a
high quality thermostat.
The volume of snow produced is regulated via
the output knob.
CAUTION: The escape nozzle will heat up
during operation. Therefore do not touch
the nozzle until it has cooled down
completely.
16/31
an
appropriate
vaporization
00025503.DOC, Version 1.3
Publicidad
