Publicidad
Idiomas disponibles
Idiomas disponibles
3. Remove the outer burr by grabbing and lifting the burr wire (see
Diagram A), twisting counterclockwise (to the left) until it unlocks
from the grind chamber, then lift away.
4. Clear coffee from the grind chamber and discard.
5. Inspect both burrs for coffee beans or foreign materials (rocks,
sticks, unroasted coffee beans, etc.) that may be stuck. Remove
all stuck material and clean burrs as instructed in the "Cleaning"
section of this manual.
6. Reinstall burr and load bin. Run grinder for 5 seconds to check that
it operates as expected. The grinder should spin quietly and
at an even speed. If the grinder is making an unexpected noise,
repeat this process and carefully inspect to ensure that all coffee
particles have been cleared out.
7. If the problem persists, please contact Fellow customer service
at hello@fellowproducts.com and submit a request.
REMOVING AND CLEANING THE GRINDING BURRS
CAUTION: The grinding burrs are sharp, please handle carefully!
1. Unplug your grinder and empty it of coffee.
2. Remove the load bin by twisting it counterclockwise (to the left)
until it unlocks from the grinder, and lift away.
3. Next remove the outer burr. The outer burr is permanently molded
into a plastic carrier with a wire handle attached. This assembly is
locked in the grind chamber with a twist-lock mechanism similar to
the hopper; simply grab the wire handle and twist counterclock-
wise (to the left) until the burr carrier disengages from the grinder,
then lift away.
Do not disassemble the burrs further. Using a stiff brush, gently
brush coffee dust off of the burrs and out of the grind chamber,
then replace the outer burr.
10
Diagram A:
Exploded View
Outer Burr
Load Bin Lid
Load Bin
Burr Wire
Outer Burr Overmold
11
Publicidad
