Publicidad
Idiomas disponibles
Idiomas disponibles
EN
8
PAGODA MANUAL (ALUMINIUM POLES)
ASSEMBLY
TIP: Use a groundsheet to prevent the tent canvas f rom getting dirty during assembly.
1.
Lay the four corner pieces approximately the correct distance f rom each other.
2. Lay all the horizontal tubes between the corner pieces and connect them together using
the connector piece. See f igure 1b.
Pay attention - The horizontal tubes for the pagoda tent of 3 x 3 m are made in one piece.
3.
Fit the connected tubes into the corner pieces. Ensure that the keder groove is facing
down.
4. Connect the corners of the roof f rame diagonally with each other using the steel cables.
Tension the cables manually and evenly using the turnbuckles. Ensure that the f rame is
not skewed and ensure that the keder groove is facing down.
Figure 1a
Figure 2a
Figure 2b
Figure 3a
5.
Lay the roof canvas over the f rame. Pull the
nylon loops over the corners as indicated in
f igure 4. On one of the corners there is a
drawstring to make it easier to pull the last
loop over the corner.
6. Place the pole so that the roof canvas is
placed under tension. Slide the peak of the
roof over the top of the pole and slide the
pole base over the uppermost cross cable
into the centre. Aff ix the pole with the
attachment clamp at the bottom.
7.
Attach the loops around the roof f rame to
the inside of the sloping sides of the roof
canvas. This gives the roof structure extra
support.
Figure 1b
8. Place two poles on one side beneath the f rame so that the roof f rame lies at an angle (see
f igure 7a). Ensure that the widening of the keder groove is at the top of the vertical poles
and that the keder grooves are f itted at an angle of 45° in relation to the corners of the
tent (f igure 7b).
Figure 2c
9. Place the two other poles in the same way and f it a base plate beneath each pole. Ensure
that the openings in the base plate correspond to the openings at the bottom of the pole,
so that you can aff ix the poles in the base plates.
Figure 3b
9
PAGODA MANUAL (ALUMINIUM POLES)
Figure 7a
EN
Figure 4
Figure 5
Figure 6
Figure 7b
Publicidad
