Charging Battery Pack - Ryobi OP403 Manual Del Operador

LED FUNCTIONS FOR BATTERY CHARGING
See Figure 3, page 8.
NOTE: The LED feedback described below is for battery charging only. The LEDs function differently when the product is
used to charge USB devices. See Using the Charger With a USB Device for details.
BATTERY RED
PACK LED
Power On
Plugged into AC
p o w e r s u p p l y
without battery
pack
Testing
Hot battery pack
Cold battery pack OFF
Deeply discharged
Defective
Defective Flashing
• If defective, try to repeat the conditions a second time by removing and reinstalling the battery pack. If the LED status repeats a
second time, try charging a different battery.
• If a different battery charges normally, dispose of the defective pack (see Maintenance section).
• If a different battery also indicates "Defective," the charger may be defective.

Charging Battery Pack

Fast charging OFF
Battery Pack is Ready
OFF
Battery full
*Charger LED will remain ON for approximately 5 minutes when charging is complete. When the battery is
100% charged, the battery LEDs will all turn off.
NOTE: MAINTENANCE INFORMATION BEGINS ON PAGE 7
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
OPERATION
GREEN ORANGE
LED LED
ON OFF OFF
OFF ON
Flashing OFF
Flashing OFF
ON* OFF
This product has a Three-year Limited Warranty.
For Warranty details go to www.ryobitools.com
ILLUSTRATIONS START ON PAGE 8.
Ready to charge battery pack.
When battery pack reaches cooled temperature, charger begins charge
mode.
When battery pack reaches warmed temperature, charger begins
charge mode.
Charger conditions battery until normal voltage is reached, then begins
charge mode.
Battery pack or charger is defective.
Battery is being charged.
Battery charging is complete.
6 — English
ACTION