Craftsman 171.926501 Manual Del Propietário página 16

MITER GAUGE ASSEMBLY
1. Screw the #10-16 x 1/2" type BT self-
tapping pan-head screw (21) through the
round hole in the miter bar (13) and into
the protractor head (14), as shown in
Fig. 9.
2. "Nghten the screw so that the screw
head just touches the miter bar. The
protractor head should turn easily. If not,
loosen the screw slightZy.
3. Insert the #10-24 x 3/4" carriage bolt
(22) through the square hole in the miter
bar and slot in the miter gauge and
secure with the small knob (15), and
13/64" I.D. x 9/16" O.D. washer (18).
Figure 9 _[_9
16