Craftsman 171.926501 Manual Del Propietário página 24

I _'WARNING I
Always make sure
that the router is turned OFF and the
power cord UNPLUGGED before
making any adjustments.
I _WARNINGI
For accuracy
in routing and improved control, the
workpiece should be held against the
router table fence when routing.
ADJUSTING THE FENCE
FACING
The right and left fence facings, identified
with "R" and "L" respectively, attach to the
front face of the router table fence, and
can be adjusted inward or outward from
the router bit, to allow proper clearance for
different sized bits. To provide the best
support during routing operations, the
fence facings should be as close to the bit
as possible without being able to come in
contact with the bit (typically about 1/4"
from the bit is a suitable distance).
1. Loosen the two wingnuts on the backs
of the fence facings and slide them
inward or outward from the router bit,
as needed.
I _,WARNING I Always make
sure
that the fence, fence facings, and guard
cannot come in contact with the router
bit. Failure to do so will result in damage
to the router table and can cause personal
injury.
2. Once the fence facings are in the
desired position, tighten the wingnuts
SECURELY.
Figure 14
Wingnuts (on
back of fence)
24