Publicidad
Idiomas disponibles
Idiomas disponibles
Reversing the door
The door can be changed from left and right side. No special requirement, all the door is opened from
left side. If required to open from right side please refer to the following direction.
IMPORTANT: all parts removed must be saved to do the reinstallation of door.
1. Close the glass door, and remove the decoration plug n°2. Unscrew the top hinge pin n°3 and
lower hinge pin n°8. Be careful to support the glass door with hands to prevent it dropping after
removing the pins (fig. 1 & 2).
2. Pull down to remove the glass door and place it on a padded surface to prevent scratching it.
3. Remove the right top hinge plate n°4 by unscrewing the four screws n°1 and get the left top hinge
plate n°6 from the plastic bag that includes the instruction manual then install it at the designated
position on the opposite side (fig. 1).
4. Remove the lower plate n°7 by unscrewing the four screws n°9. Then turn it around and refit it on
the opposite side (fig. 2).
5. Turn around the glass 180° and refit the hinge pin n°3 and 8 through the top hinge plate n°6 and
lower hinge plate n°7 into the door. Make sure that the spacers which the hinge pins sit on are
correctly positioned.
6. Leveling the door by adjusting the screws that are used to fix the top hinge plate and lower hinge
plate.
1) Screws
2) Decoration plug
3) Top hinge pin
4) Right top hinge plate
5) Glass door
6) Left top hinge plate
7) Lower hinge plate
8) Lower hinge pin
9) Screws
10) Cabinet
11) Screws
12) Lower hinge plate
13) Screws
14) Lower part of the cabinet
49
Publicidad
