Beta 599DGT Instrucciones página 15

TRACK MODE OPERATION
START
Max. Target Value
Current Target Value
Current Torque Value
Buzzer
Buzzer
Note:
1. If appears, that means more than 110% of torque as stated in the specifications has
been applied to this wrench.
The wrench will start working again after a few seconds; however, it should be checked for
calibration at a Beta authorized centre as soon as possible.
2. If you apply torque over 5 N-m, the LCD display will start to display the torque value. If the
applied torque is less than 5 N-m, the LCD display does not show any changes in value.
3. The green LED will be on for 90% of maximum setting torque.
4. The red LED will be on for 100% of maximum setting torque.
(Sistem initial)
* Note 1
Appliy Torque Over 5 N-m
* Note 2
Reach 90% od Max. Target Value
* Note 3
Green LED
Over 90% of Set Torque
Reach Max.Target Value
* Note 4
Red LED
Reach Max. Set Torque
15