Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: See PARTS AND FEATURES
for
belt number.
Loop the other end of the belt on the belt
pulley on the agitator.
Insert the agitator by placing
the rounded
portion
of the end cap down into the slot
in the nozzle base.
NOTE:
It may be necessary
to hold the
furniture
guard out of the way in order to
allow proper insertion
of the agitator
into
the nozzle base.
Agitator
Nozzle
Base
Furniture
Base
Guard
End
Slot
Cap
NOTE: Care must be taken due to the
belt tension
during reassembly.
Press firmly,
checking
to
see that
each end is
completely
inserted.
Check to see that the belt is centered
on
the belt pulley. Turn the agitator
with your
fingers to see that it turns freely_
To re-attach
the agitator
_
cover, insert
the six (6)
tabs into the
_
six slots
along the
_.
front edge of
the nozzle
Tabs/
base.
Slots
Locking
Tabs
J
Lower the agitator
cover to its original
position.
After positioning
the agitator
cover, push forward on the two (2) locking
tabs in order to ensure that they are
securely
in place.
Re-fasten
the furniture
guard retain-
ers to the
posts on
both sides of
the agitator
cover°
Agitator
Cover
Furniture
Guard
Retainer
NOTE:
If the agitator cover is not installed
correctly,
you may experience
a loss of
performance
and possible
agitator
vibra-
tion, etc°
Headlight
Wire
ook,obs
I
N
ecurety In
J
[i[
Place
Make sure the headlight
wires are tucked
securely
in place.
Replace
the
nozzle cover
and secure
the latches.
Nozzle
Cover
1
18
Publicidad
