Kenmore 116.38512 Manual Del Propietário página 9

Theattached
hoseswivels to
makecleaning
Swivel-.
easier in every
direction.
Remove the
hose from the
hose clip by
pulling straight
out.
TELESCOPING WAND WITH
SUCTION CONTROL SLIDE
SOME MODELS
Crevice
Tool
Telescoping
Wand
Remove the
telescoping
wand from
its storage
position,
Remove the crevice tool from its storage
position in the wan& Turn the locking ring to
the UNLOCK position.
Extend the wand to its full length_ Turn the
locking ring to the LOCK position, Attach
the extension wand onto the open end of
the hose.
Suction
Wand -'-'_ "_ Control Slide
Upper
Wand
Align the tabs on the extension wand with
the "J" slots in the hose. Push the wand into
the hose and twist to the right to lock.
To achieve maximum reach
with the attachments, add
the crevice tool to the end Hose.
of the wand by inserting
and twisting slightly suction
Control
Telescoping
Wand,
Crevice
Tool
When using the
dusting brush or
the combination
brush, they may
be attached
directly to the
wand or placed
on the end of
the crevice tool.,
TO OPERATE SUCTION
CONTROL SLIDE
Telescoping Wand
When using
attachments for
cleaning
draperies, small
rugs with low pile
and other
delicate items,
twist the suction
control slide to the open position. This lever
is located on the telescoping wand, close to
the hose.
\
Suction
Control
Slide
This will reduce suction for ease of cleaning.
NOTE: Return suction control slide to the
closed position for normal cleaning..
CAUTION
When using attachments, be careful
not to overextend the stretch hose
when reaching. Trying to reach
beyond the hose stretch capability
could cause the cleaner to tip over.
Make sure the carpet/bare floor
selector is in the bare floor position,
Damage to the floor surface may
occur if the carpet setting is used,
7-' _' _ • _ .........