Publicidad
Idiomas disponibles
Idiomas disponibles
5.
Troubleshooting
WARNING!
•
In case of failures or malfunctions, always
unplug the appliance immediately.
•
Only perform the steps described in this
instruction manual! All further inspection,
maintenance and repair work must be
performed by an authorized service center or a
similarly qualified specialist.
•
Should you require spare parts, always obtain
them from an authorized seller. Do not use
spare parts that are not recommended by the
manufacturer!
Possible
Problem
cause
Power plug
not connected
to electrical
outlet.
Supply cord is
damaged.
Overload
Appliance
switch was
does not
activated.
operate.
Safety guard
is not closed.
Speed not
properly set.
Bowl is not
fully raised.
Holding bolts
on bowl
Bowl does
are soiled
not fit back
with dough
into place.
or other
foodstuff.
Solution
Connect power
plug to a suitable
electrical outlet.
Plug it in tightly.
Have supply cord
replaced by the
manufacturer, its
service agent or
similarly qualified
persons.
See information
about overload
switch in this
manual
(
Operation).
Close the safety
guard.
Set a speed. Make
sure the speed
regulator locks into
place in a speed
setting.
Fully raise the bowl.
Clean the appliance/
bowl (
After use).
- 16 -
Possible
Problem
cause
Bowl is too
full.
Appliance
overheats.
Appliance
has been
operated for
too long.
Bowl or
accessory
not correctly
attached.
Appliance is
noisy.
Worn
bearings/
damaged
gears.
Speed setting
Gearing
cannot be
cogs are
selected.
misaligned.
For the circuit diagram, please see illustration at the
end of this manual.
a.
Overcurrent protector
b.
Centrifugal switch
c.
Yellow
d.
Black
e.
Blue
f.
Red
For the interconnection diagram, please see
illustration at the end of this manual.
1.
Start/Stop button
2.
Overload switch
3.
Distance switch of safeguard
4.
Distance switch of lifter
5.
Power plug
6.
Running capacity
7.
Starting capacity
8.
Motor
6.
Disposal
Environmental Protection
Discarded electric appliances are
recyclable and should not be discarded
in the domestic waste! Please actively
support us in conserving resources and
protecting the environment by returning
this appliance to the collection centres.
Solution
Turn off and unplug
the appliance and
remove some of the
GB
bowl's contents.
Turn off and unplug
the appliance and
let it cool down for at
least 30 minutes.
Turn off and unplug
the appliance.
Remove and refit
the bowl/accessory.
Contact
manufacturer, its
service agent or
similarly qualified
persons for repair/
exchange of parts.
Turn off and unplug
the appliance and
manually turn the
accessory slightly.
Then try to select
speed setting again.
Publicidad
