Publicidad
Idiomas disponibles
Idiomas disponibles
EN
9.3
REPLACE THE BELT
Make sure to turn off the bail lever and remove the battery
pack(s) before performing any maintenance task on your
snow thrower.
1. Remove the screws (18) on the side wear pad (27).
2. Turn the large pulley (29) counterclockwise while you
remove the remaining belt (28).
3. Turn the new belt (28) onto the pulleys (29).
4. Install and tighten the screws (18) that you removed.
9.4
REPLACE THE IMPELLER
WARNING
English
Make sure to turn off the bail lever and remove the battery
pack(s) before performing any maintenance task on your
snow thrower.
1. Remove the 4 sets of nuts and bolts on the middle steel
plate.
2. Remove the 4 sets of nuts and bolts on each side.
3. Remove the impellers (10).
4. Install the new impellers (10).
5. Tigthen the 8 sets of nuts and bolts that you removed.
9.5
REPLACE THE SKID PLATES
The range of adjustable height for skid plates is 1.5mm,
when putting the bolts through the U-hole on the skid
plates.
1. Loosen the 2 sets of bolts (17), spacers (31) and nuts (19)
that attach the skid plates (30) to the snow thrower
housing.
2. Remove the skid plates (30).
3. Install the new skid plates (30).
4. Do the same operation on the other side.
9.6
STORE THE MACHINE
•
Clean the machine before storage.
•
Make sure the motor is not hot when you store the
machine.
•
Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
•
Replace the damaged parts.
•
Tighten the bolts.
•
Speak to a person at an approved service center.
•
Store the machine in a dry area.
•
Make sure that children cannot come near the machine.
12
WARNING
NOTE
Publicidad
