HAMPTON BAY DSHD5979B Guía De Uso Y Mantenimiento página 5

Installation
1
Preparing the crossbar assembly
□
Unscrew the two mounting balls (1) and two rubber washer (5)
from the fixture body (A).
□
Remove the crossbar assembly (AA) from the fixture body (A) and
keep the crossbar assembly (AA) and two mounting balls (1) for
later use.
□
Unscrew the two mounting screws (3) from the fixture body (A).
□
Remove the cage (2) and the EPE (4) from the fixture body (A) and
keep the cage (2) , the two mounting screws (3) and two rubber
washer (5) for later use.
AA
3
Test fitting backplate on the fixture body to the crossbar assembly
□
Fit the backplate on the fixture body (A) to the crossbar assembly (AA) and secure with the mounting balls (1).
*If this does not work, adjust the length of the mounting screws on the crossbar assembly (AA) by unscrewing the preassembled
hex nuts.
*Then, screw the mounting screws in or out of the crossbar assembly (AA) until the desired length is achieved.
□
Once the backplate on the fixture body (A) is secure, remove the mounting balls (1) and fixture body (A) and proceed to Step 4.
5
1
NOTE: The backplate on the fixture body (A) should be snug against the wall and
the mounting balls (1).
AA
2
Installing the crossbar assembly
NOTE: Prior to installation, close or cover the sink
drain and/or any vents near the installation site to
prevent loss of mounting hardware if dropped.
□
Secure the crossbar assembly (AA) to the outlet box (not
included) with the outlet box screws (BB). Tighten until snug.
NOTE: The preassembled mounting screws on
the crossbar should protrude outward.
4
2
3
5
Please contact 1-855-HD-HAMPTON for further assistance.
AA
BB
1
A
HAMPTONBAY.COM