Publicidad
Idiomas disponibles
Idiomas disponibles
Installation instructions
If the range is pulled from the wall for any reason, always repeat this procedure
to verify the range is properly secured by the anti-tip bracket. Never completely
remove the leveling legs or the range will not be secured to the anti-tip device
properly.
Step 5. Plug in and place
WARNING
BEFORE OPERATING OR TESTING, follow the grounding requirements on pages
17 ~ 18 in this manual. Improper connection of the grounding plug can result in a
risk of electric shock.
• All gas ranges come with a power cord. The power cord is connected to the rear
of the range. Please review "Electrical requirements" on pages 17 ~ 18.
• The electrical system, including the power cord, is preinstalled and prewired at
the factory. Altering any part of this system may result in a short or overload.
1. Plug in the power cord. Make sure the outlet meets local or national electrical
codes as referenced on pages 17 ~ 18.
2. Slide the range into place.
3. Check the gas supply line to make sure it did not get damaged and it stayed
connected during positioning.
4. Check to make sure the back leg of the range has slid into the anti-tip bracket.
Carefully tip the range forward to ensure that the anti-tip bracket engages the
back brace and prevents tip-over.
22 English
DG68-01600A-00_IM_NSG6DG8700SRAA_EN+MES+CFR.indb 22
DG68-01600A-00_IM_NSG6DG8700SRAA_EN+MES+CFR.indb 22
Step 6. Level the range
1. Make sure the range is positioned where
2. Using a wrench, level the range by
Leveling leg
• Adjusting the two front legs is usually
• Adjust the leveling legs only as far as
3. If range is next to or between cabinets,
4. Position an oven rack in the center rack
5. Check the level of the range with a
6. After the range becomes level, slide the
you want it.
turning the front leveling legs in or out
as necessary. Counterclockwise shortens
the leg and lowers the range. Clockwise
lengthens the leg and raises the range.
NOTES
sufficient, but adjust all four legs if
necessary.
necessary to level the range. Extending
the leveling legs more than necessary or
removing legs can cause the range to be
unstable.
make sure the cooktop (without the
surface burner grates) is level with the
countertops.
position.
carpenter level using the two positions
shown at right.
range away from the wall so that the
anti-tip bracket can be installed.
2023-12-20 오후 2:54:20
2023-12-20 오후 2:54:20
Publicidad
