Publicidad
Idiomas disponibles
Idiomas disponibles
iNSTALLiNG
YOUR
REFRIGERATOR
Unpacking Your Refrigerator
1.
Remove all packaging material. This includes the foam base and all adhesive
tape holding the refrigerator
accessories inside and outside. Slide out and
remove the plastic or foam guard used to secure the compressor
from shipping
damage due to vibration and shock.
2.
inspect and remove any remaining packaging, tape or printed materials
before powering on the refrigeraton
3.
Check to be sure you have all accessories and parts stated in the Parts and
Features section.
Proper Air Circulation
To ensure that your refrigerator
works at the maximum efficiency
it was
designed for, you should install it in a location where there is proper air
circulation,
plumbing and electrical
connections.
The following
are recommended
clearances around the refrigerator
:
Sides ................... 3/4" (t9mm)
Top ...................... 2" (50mm)
Back .................... 2" (50mm)
Electrical Requirements
Make sure there is a suitable power outlet (t15 volts, 15 amps outlet) with
proper grounding to power the refrigeraton
Avoid the use of three prong adapters or cutting off the third grounding
prong in order to accommodate
a two prong outlet. This is a dangerous practice
since it provides no effective grounding for the refrigerator
and may result in
shock hazard.
Installation
Your refrigerator
is designed for freestanding
installation only. It should not be
recessed or built in. Place the refrigerator
on a floor strong enough to support it fully
loaded. When moving the refrigerator,
never tilt it more than a 45degrees
angle.This
could damage the compressor
and the sealed system.
If the refrigerator
has been tilted more than 45 degrees, let it stand in an upright
position for at least 24 hours prior to plugging it into the power source. This
will allow the refrigerant to settle and reduce the possibility of a malfunction in
the cooling system.
Plug the refrigerator
into an exclusive, properly installed grounded wall outlet.
Do not under any circumstances cut or remove the third (grounding) prong from
the power cord. Any questions concerning power and/or grounding should be
directed toward a certified electrician
or an authorized service centen
After plugging the appliance into a wall outlet, allow the unit to cool down for
2 3 hours before placing food into the refrigeraton
-6-
Publicidad
