Publicidad
Idiomas disponibles
Idiomas disponibles
English
Owner´s manual
Assembling the side discharge chute
NOTE: When use side discharge function. First
need remove the grass bag and plug the mulching
plug.
1. Lift the side discharge cover with one hand and
hook in the side discharge duct with the other
hand.
2. Release the side discharge cover to secure the
duct in position.
Install cables and control panel*
With your lawn mower, the two cables must be installed. Please proceed as follows:
* Depending on model
1. The long cable
controls the self-
propulsion and is for
the self-propelled
lever,the short cable is
for the brake lever.
Checking the engine oil level and filling with engine oil
WARNING:The following procedures and adjustments must be performed before the
engine is started.
Do not attempt to make any of these adjustments while the engine is running.
To prevent engine damage the engine is shipped without oil or petrol. The engine must be filled
with the correct grade of oil and petrol before starting the engine.
NOTE: Running the engine with a low oil level will cause engine damage. It is recommend that
high detergent, premium quality 4-stroke engine oil used.
WARNING: Always use high quality detergent oil classified (or equivalent e. g SAE 15W/40,
often termed as 4 Stroke lawn mower oil. Never use additives with recommended oil. To prolong
the life of your engine it is important that the oil is changed after the first 20 hours of use.
32
2. Install the cup
holder and insert the
short cable for the
brake lever through
the hole in the cup
holder and the long
cable for the self-
propelled lever behind
the cup holder.
3. Release the brake
lever and self-drive
lever from its respective
anchorage. Insert the
end of the long self-
propelled cable into
the hole provided on
the selfpropelled lever.
Pass the end of the
short brake lever cable
through the hole in the
brake lever.
4. Replace the brake
lever and the self-
drive lever in the
respective hole on
the upper retaining
bracket.
Publicidad
