Publicidad
Idiomas disponibles
Idiomas disponibles
To check the engine oil level, stop engine and
place the mower on a level surface.
1. Remove the oil filler dipstick and wipe oil from it
with a clean cloth.
2. Insert the dipstick into the oil filler neck.
3. Then remove the dipstick and check the oil level. the oil level must be between the Min and
Max marks on the dipstick. I f near the lower level, fill to upper lever with the recommended oil
((or equivalent t e. g SAE 15W/40). Do not overfill. Wipe away any spilt oil).
4. Align the ribs of the cap with the groove of the filler neck. then rotate 1/4 turn to secure it.
Filling with engine fuel
WARNING: Always use clean, fresh unleaded petrol. Purchase fuel in quantities that can
be used within 30 days. Never mix oil with petrol. Do not fill into the base of neck to allow for
fuel expansion Do not overfill the fuel tank.
To prevent engine damage the engine is shipped without oil or petrol. The engine must be filled
with the correct grade of oil and petrol before starting the engine.
WARNING: Petrol is highly flammable and extreme precaution must be taken when
handling or working with it. Keep out of reach of children.
Refuel in a well-ventilated area with the engine stopped. Do not smoke or allow flame or
sparks in the area where the engine is refueled or where petrol is stored. Avoid repeated or
prolonged contact with skin or inhalation of vapour.
1. Clean the area around the petrol filler cap before removing the cap. Remove the warning tag,
check the fuel level.
2. Refill the tank if the fuel level is low.
3.Refuel carefully to avoid overfilling or spilling fuel. There should be no fuel in the filler neck.
4. Clean up any overflow or splashes of petrol before starting the engine.
5. Tighten the filler cap after filling, finger tight on.
Setting the cutting height
WARNING: Adjust the cutting height only
when the engine is switch off the spark plug boot
has been pulled.
The cutting height is centrally adjusted with Cutting
height adjusting handle. Different cutting Heights
can be selected.
Pull the adjusting handle out and select the
desired cutting height. The handle snaps Into the
desired position.
From position 1 to position 7*. The cutting height
range from 25mm to 75 mm.
* Depending on model
Setting required function
This lawn mower has four functions. These functions can be converted by changing accessory
English
Owner´s manual
33
Publicidad
