English
Owner´s manual
Lithium battery starting operation*
* Only electric model DLM 5301E - DLM 5303E
Battery charge
a. Plug the charger input wire into the power socket and the power indicator light is on (green)
b. Plug the battery into the charger slot and put it in place. When the battery is charging, the
charging indicator light is on (red), and the green indicator light goes out.
c. When the battery is fully charged, the red indicator light goes out, the green indicator light is
on.
d. Remove the battery and remove the charger input line from the socket.
Install the battery
a. Open the battery case
b. Insert the battery into the slot and push it in place
c. Close the battery compartment cover.
Start up operation
a. First of all, check the machine and add fuel and lubricating oil
b. Pull the flameout rod in place and press the start button.
When the gasoline engine starts, release the start button.
Take out the battery
a. Open the battery compartment, press the battery button,
b. Take out the battery, release the battery buckle and close the battery compartment.
Stop the engine
Release the engine brake lever, it will return to its
initial position, the engine will automatically switch
off.
WARNING! The blades will continue to rotate
for a few seconds after the engine has stopped.
Disconnect the spark plug cap from the mower if
you are going to be away.
To lean a flooded engine
NOTE: if the engine won't start after you have operated the starter several times, the engine
may be flood with excess fuel. Use following procedure to clear and start a flooded engine.
1. Release the engine start/stop lever to stop engine.
2. Remove the spark plug, dry it, and then reinstall it.
NOTE: Install the spark plug carefully by hand, to avoid cross-threading. After the plug is
seated tighten 1/8 to 1/4 turn with socket spanner of spark plug to compress the washer.
1. Pull the engine start/stop lever toward upper handle.
2. Operate the starter as described above.
35