Publicidad
Idiomas disponibles
Idiomas disponibles
Section 4: Operation
OPERATmNG
THE
G E N E RATO R
Starting the En
Disconnect aH electricai ioads from the generator. Use the
following
start
instructions:
i.
blake
sure unit is on a level surface.
mNPORTANT:
Failure
to start
and operate
unit on a level
surface
will
cause the unit
not to start
or shut down
during
operation.
2.
Turn
red fuel valve to"On"
position
(Figure
4).
!111_
_Mff__
...............................................................
\
/
!l_
3.
Start
engine
according
to instructions
given in engine
a, wAR.I.G
1
WARNING
DO NOT touch hot surfaces and avoid hot exhaust gases.
Allow equipment
to cool before touching.
Keep at least 5 ft, (152 cm) clearance on all sides of generator
including overhead.
Code of Federal Regubtion
(CFR) Title 36 Parks, Forests, and
PuNic Property
require equipment
powered by an internal
combustion
engine to have a spark an'ester, maintained
in
effective working
order, complying
to USDA Forest service
standard 5100- I C or later revision. In the State of California
a
spark arrester
is required under section 4442 of the California
Public resources code. Other
states may have similar laws.
Connecting
Electrical
Loads
o Let engine
stabilize
and warm
up for a few minutes
after
starting.
o Plug in and turn
on the desired
120 and/or
240 VoltAC,
single phase, 60 Hz electrical
loads.
o DO
NOT
connect
240Volt
loads to the
120Volt
duplex
receptacles.
o DO
NOT
connect
3-phase
loads to the generator.
o DO
NOT
connect
50 Hz loads to the generator.
o DO
NOT
OVERLOADTHE
GENERATOR,
See
"Don't
Overload
Generator".
When
starting engine, pull cord slowty until resistance is felt
and then pull rapidly to avoid kickback.
NEVER start or stop engine with electrical
devices plugged in
and turned
on.
NOTE:
If engine
starts
after
3 pulis but fails to run, or if
unit
shuts down
during
operation,
make sure
unit is on a
level surface
and check
for
proper
oil level in crankcase.
This unit
may be equipped
with
a low oil protection
device.
See engine
operator's
manual.
See "Don't
Overload
Generator".
Start generator
and let engine stabilize before connecting
electrical
loads.
Connect
electrical
loads in OFF position,
then turn ON for
operatiom
Turn electrical
loads OFF and disconnect
from generator
before
stopping
generator_
0
Publicidad
