Publicidad
Idiomas disponibles
Idiomas disponibles
Section 4: Operation
How
to Use the SprayTips
,_
CAUTION!
NEVER exchange spray tips without
locking the safety latch on the trigger.
The quick-connect
on the nozzle extension allows you to
switch between five different spray tips The spray tips vary
the spray pattern as shown below (Figure t4)
Follow these instructions
to change spray tips:
I._ Engagethe safety latch on the spray gun
2..
Pull back the collar on the quick-connect
and pull the
current spray tip off. Store the spray tips in the space
provided on the handles storage panel,
NOTE:
For a more gentle rinse, select the white 40 ° or
green 25 ° spray tipTo scour the surface, select the yellow
15° or red 0 ° spray tipTo apply chemical, select the black
spray tip..
3,
Pull back on the collar, insert the new spray tip and
release the collar_Tug on the spray tip to make sure it
is securely in place.
4_
For most effective cleaning, keep the spray tip from 8
to 24 inchesaway from the cleaning surface. If you get
the spray tip too close, you may damage the cleaning
surface.
5..
DO NOT get closer than 6 inches when cleaning tires_
Cleaning
and Applying
Chemical
CAUTION!
You must attach
all hoses before you
start the engine. Starting the engine without all the hoses
connected and without the water turned ON will damage
the pump
IMPORTANT:
Use soaps designed
specifically for
pressure
washers. Household detergents could damage
the pump
To apply detergent
follow
these steps:
I..
Review the use of the spray tips.,
2_ Prepare the detergent solution as required by the
manufacturer.
3_
Hang the detergent solution on the "j" hook attached
to the accessory tray, as shown in Figure IS
Low Pressure
Use to
apply
:heroical
Black
l
White
Red
40 °
0°
High Pressure
I
I'
Green
Yellow
25 °
150
Publicidad
