Publicidad
Idiomas disponibles
Idiomas disponibles
5
Maintenance
GENERAL
HAINTENANCE
RECOHHENDATIONS
The pressure washer warranty does not cover items that have
been subjected to operator abuse or negligence.To receive full
value from the warranty,, the operator must maintain the
pressure washer as instructed in this manual.
• Some adjustments will need to be made periodically to
properly maintain your pressure washer.Check the spray
gun and adjustable nozzle extension assembly for wear.
• All maintenance in this manual and the engine owner's
manual should be made at least once each season.
• Once a year you should clean or replace the spark plug,
clean or replace the air fllcer.A new spark plug and clean
air filter assure proper fuel-air mixture and help your
engine run better and last longer. Please refer to your
engine owner's manual for more detaiIs,,
• if equipped with inflatable tires, keep the air pressure at
the value marked on the tire or within 15 and 40 psi,
Before Each Use
I_
Check engine oil level
2.
Check water inlet screen for damage,
3,
Check in-line filter for damage,
4.
Check high pressure hose for leaks
5.
Check detergent siphoning tube and filter for damage.
6_ Check spray gun and nozzle extension assembly for leaks.
7.
Rinse out garden hose to flush out debris before
connecting to pressure washer.
PRESSURE
VVASHER
MAINTENANCE
_
AUTION!
Water spraying from a leak is capable
of injecting material into skin_ Inspect hose each
time before using it NEVER repair a high pressure
hose Replace it with another hose that exceeds the
maximum pressure rating of your pressure washer.
Check
Detergent
Siphoning
Tube
Examine the filter on the detergent tube and clean if
clogged,The tube should fit tightly on the barbed fitting,
Examine the tube for leaks or tears, Replace the filter or
tube if either is damaged,
Cleaning
Detergen
t Siphoning
Tube
if you used the detergent siphoning tube, you must flush it
with clean water before stopping the engine,.
I,
Place the chemical iniection siphon/filter in a bucket full
of clean water.
2.
Attach the black low pressure spray tip.
3.
Flush for I-2 minutes,
4.
Shut off the engine_
IMPORTANT:
Simply shutting OFF engine will not
release pressure in the system, When
the engine has
shut down, squeeze
the trigger on the spray gun to
relieve
the pressure in the hose°
Check
Gun and Nozzle
Extension
Examine the hose connection to the spray gun and make
sure it is secure Test the trigger by pressing it and making
sure it "springs back" into place when you release it. Put
the safety latch in the ON position and test the trigger, You
should not be able to press the trigger.
Check
In-Line
Filter
Refer to Figure 17 and service the in-line filter if it
becomes clogged, as follows:
Check
and Clean
Inlet
Screen
Examine the screen on the water inlet Clean it if the
screen is dogged or replace it if screen is damaged,
Check
High
Pressure
Hose
The high pressure hose can develop leaks from wear,
kinking, or abuse,.Inspect the hose each time before using
iL Check for cuts, leaks,abrasions or bulging of cover,
damage or movement of couplings,, If any of these
conditions exist, replace the hose immediately.
Nozzle Extension
Detach spray gun and nozzle extension from high
pressure hose Detach nozzle extension from spray gun
and remove o-ring and screen from nozzle extension,
Flush the screen, spray gun, and adjustable nozzle
extension with clean water to dear debris
Publicidad
